Surfapore AG

  • 1L
  • 4L
SKU: 171
Surface Category: 
Ceramic Tiles
Concrete & Stone Clear Varnish

Estimated consumption rate 24-30 m²/L for polished surfaces and 8-10 m²/L for other surfaces.

Nanotechnology protection for marble, concrete, wood,  porcelain surfaces and walls from graffiti staining

How It Works: 

SurfaPore AG (Anti-graffiti) can be easily applied on your existing or new surfaces to preserve their appearance. It creates an impermeable and invisible barrier by blocking even the finest pores of these surfaces.

Surface Description: 

Nanotechnology for protecting marble, porcelain surfaces and walls from graffiti staining

General Characteristics: 

SurfaPore AG (Anti-Graffiti) is a water based graffiti protectant. It contains nano-sized particles that fit into the pores of a surface, penetrate, “flood” and seal the pores that can accumulate graffiti. These nanoparticles have the ability to self polymerize and create an impermeable 3D network which binds permanently onto the pores and the surface. Paint simply sits on the top of the 3D network and does not adhere to the surface

  • Anti-graffiti properties
  • Graffiti is cleaned just by water
  • Does not change natural appearance
  • Long Lasting & UV Resistant
  • Makes cleaning easier
  • Easily Applicable
  • Cost Effective

Tiles, cladding, plaster walls, marble, porcelain tiles, stones.

How to Apply: 

The application surface should be dry and clean. No dilution is required. 2 applications of SurfaPore AG can be applied with brush, roller or spray gun on the existing vertical surfaces. For non-absorbing surfaces (shiny marbles, granite surfaces), remove any excess by using a damp absorptive towel or paper. Continue polishing the surface, until no apparent wet residue is visible on the surface. Absorbing surfaces (plaster, flamed stone) will absorb most of the applied SurfaPore AG. Ensure that there is no wet residue left after 5 minutes from application, by using a moist cloth. It is recommended to remove graffiti as soon as possible from the damaged surfaces. To achieve that you have to use a stiff brush and warm water, or alternatively, a steam cleaner is ideally recommended. You have to re-apply SurfaPore AG after 5-7 graffiti removals for polished surfaces and 3-4 for other surfaces. Maximum effectiveness is achieved a week after application.